![]() Re-authenticate users upon expiration of the tunnel: disabled Supported tunneling protocol: IPsec and WebVPNĪllowing a user to store the XAUTH password locally: disabled These can be viewed with the show running-config all group-policy DfltGrpPolicy command, shown here: There is a default group policy, called “DfltGrpPolicy” on the appliance, which supports the following default policies (you can treat this as the Base Group found on a VPN 3000 concentrator). The use of tunnel groups involves three configuration steps: A default group policy, called “DfltGrpPolicy,” exists on the security appliance for users who are not associated with a specific remote access group (similar to the Base Group on a VPN 3000 concentrator). A tunnel group might include parameters such as general policy information and information to build IPsec sessions.Ī group policy is used to define attributes associated with a user or group of users. ![]() By default, two tunnel groups already are created on your PIX/ASA: “DefaultL2LGroup” for L2L sessions and “DefaultRAGroup” for remote access sessions. Tunnel groups are used to simplify the configuration and management of your IPsec sessions. Tunnel groups allow you to define VPN session policies associated with a particular session or group of sessions, like a related group of remote access users or L2L sessions. The main IPsec change from 6.3 to 7.0 is the introduction of the tunnel group feature. Referencing the dynamic crypto map as an entry in a static crypto map (discussed in the last chapter)Īctivating the static crypto map on the PIX/ASA’s interfaceīecause I described many of the above tasks previously in this and the last chapter, the next few sections will focus on configurations unique to FOS 7.0, including:įollowing these sections, I’ll also discuss issues with remote access sessions and solutions that are provided in FOS 7.0, and an example that will illustrate the configuration of an Easy VPN Server running FOS 7.0. x” section)Ĭreating user accounts, if specified locallyĭefining IPsec transform sets for data connections (discussed in the last chapter)Ĭreating a dynamic crypto map for remote access users (discussed in the last chapter) Specifying where user accounts are located, locally on the PIX/ASA or on an AAA server (discussed previously in the “XAUTH User Authentication Configuration for 6. x” section)Ĭreating tunnel groups (this is new in 7.0) The following are tasks you need to perform on the 7.0 security appliance to set it up as a Server:Įnabling ISAKMP, including policies (discussed in the last chapter)ĭefining IP address pools (discussed previously in the “Address Pool Configuration for 6. This part of the chapter will focus on the configuration of a PIX/ASA as an Easy VPN Server. ![]() However, the configuration of an Easy VPN Server is very different than what I discussed earlier for 6. Many, many new enhancements have been made to the Server function, putting the PIX and ASA more in line with the IPsec capabilities of the VPN 3000 concentrators. Continued support for Easy VPN Server is provided in FOS 7.0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |